Residential networking

If you bring a computer to campus or purchase one while you are studying here, you can connect to the BishopNet wireless network. You may also have the option to hard-wire connect in individual rooms in some residential halls, fraternity houses, and Small Living Units (SLUs). The following buildings do not have wired access: Stuyvesant Hall, Austin Manor, 123 Oak Hill (Honors House), 4 Williams, 23 Williams (Bigelow-Reed House), 35 Williams. Austin Manor has 2 campus-wired, public-access computers available for your convenience. The SLUplexes have two wired ports in each common room: the smart TV is plugged into one, while the other is available for a student gaming console or other device.

To connect to our residential wired network you will need a Category 5 (Cat 5) patch cable with RJ45 plugs (also known as an Ethernet cable.) This cable connects your computer to the network jack in your dorm room. We recommend a 25-foot cable due to the location of these jacks.

You will also need your OWU username and password to access the network, so make sure you have that information as well.

Obtaining a Wired Connection on the Residential Network
  • Set up your computer. Plug the Ethernet cable into your computer and the other end into a network jack on the wall. (There will be one jack for each person–based on normal occupancy–in on-campus housing.)
  • Open a web browser such as Microsoft Internet Explorer or Mozilla Firefox (it will say “page cannot be displayed” or something similar- that’s ok!) and type the address: register.owu.edu.
  • You will be prompted to enter your OWU username and password.
  • Wait about 5 minutes after getting the “Thank You!” message and you will be fully online.

Link to this section of the page.

Troubleshooting Connection Issues

If you’re having issues connecting to the network with an Ethernet cable there are a few things you can try to fix it.

– Verify that all cables are connected securely and are in good condition.

– Release / Renew the connection.

  1. Go to Start -> All Programs -> Accessories -> Command Prompt
  2. Type ipconfig/release
  3. Type ipconfig/renew

– Reboot the system.

– Verify that TCP/IP properties are set to obtain IP and DNS automatically.

  1. Right click on the network connection icon on the system tray (lower right corner) and click Open Network Connections, or right click on My Network Places then Properties.
  2. Right click on Local Area Connection then Properties.
  3. Highlight Internet Protocol (TCP/IP) and click Properties.
  4. Verify that “Obtain an IP address automatically” and “Obtain DNS server address automatically” are both selected.

– Verify network adapter lights are on.

– Remove/Re-install the network adapter.

– Install a new/temp adapter.

Link to this section of the page.